Kit Contains
TerraPi EVO Frames - Right and Left TerraPi SSD Clips - Right and Left
TerraPi 40mm EVO Fan Mount
M3 x 6mm Screws - 12 Pieces
M2.5 x 6mm Screws - 8 Pieces
40MM Fan Kit (40MM Fan, 4 M3 x 12mm Screws, 4 Hex Nuts)
4 Raspberry Pi Heatsinks
Step 1: Attach Clips to SSD 
Place the SSD on a flat surface and mount the SSD clips as shown above. Use 4 M3 x 6mm screws to mount the SSD clips.
NOTE: SSD clips should lay flat on the SSD.
Place the SSD on a flat surface and mount the SSD clips as shown above. Use 4 M3 x 6mm screws to mount the SSD clips.
NOTE: SSD clips should lay flat on the SSD.
Step 2: Mount Raspberry Pi 
Place the Raspberry Pi over the SSD and previously mounted clips, aligning the four corner holes.
Secure the Raspberry Pi to the SSD assembly using 4 m2.5 x 6mm screws.
Place the Raspberry Pi over the SSD and previously mounted clips, aligning the four corner holes.
Secure the Raspberry Pi to the SSD assembly using 4 m2.5 x 6mm screws.
Step 3: Mount fan on fan mount 
Mount the 40mm fan on the fan mount using the 4 M3 x 12mm screws from the fan kit as shown above (Philips screw head facing the inside of the case).
Mount the 40mm fan on the fan mount using the 4 M3 x 12mm screws from the fan kit as shown above (Philips screw head facing the inside of the case).
Step 4: Mount fan assembly on case sides 
Use 4 M2.5 x 6mm screws to secure the fan mount / assembly to the case side panels as shown above.
Use 4 M2.5 x 6mm screws to secure the fan mount / assembly to the case side panels as shown above.
Step 5: Final assembly 
First, mount the heatsinks on the Raspberry Pi and attach the fan wires to the GPIO
Second, place bottom SSD (with Pi) between the case sides and secure with 4 M3 x 6mm screws (two on each frame plate).
Third, after mounting bottom SSD, use 4 M3 x 6mm screws to mount top SSD to case sides.
First, mount the heatsinks on the Raspberry Pi and attach the fan wires to the GPIOSecond, place bottom SSD (with Pi) between the case sides and secure with 4 M3 x 6mm screws (two on each frame plate).
Third, after mounting bottom SSD, use 4 M3 x 6mm screws to mount top SSD to case sides.
TerraPi EVO 
Manufactured under license from INUX3D
Manufactured under license from INUX3D